Interested to Buy Any Domain ? << Click Here >> for more details...
What is the basic difference between the electrical
engineering and electronic engineering?
- 4 Answers
- 6048 Views
- I also Faced
- E-Mail Answers
Answer Posted / satish
electrical which deals with electrons and ions and with
large components
electronics which deals with semi conductors and small
components
| Is This Answer Correct ? | 8 Yes | 1 No |
Post New Answer View All Answers
State kirchoff voltage law?
Electrical Engineering
The D.C. spark test is applicable to single conductor cable & assemblies of insulated single conductor cables without insulation shield,metallic sheath or metalic armor?
i am completed my degree(B.E EEE) 2014 anychance to get electrical licence plz help me
Could Please Explain briefly. Why used stabilizing resistance series with High impedance bus differential protection relay.
In what cases (circumstances)we should apply P controller, PD controller, PI controller & PID controller ?
We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible
Why Stabilising Resistor used in REF circuit ?
Describe Non I.S. Earth System and why is it used?
why and how voltage sharing in transformer, during magnetic balance test ?
Sir,In our company there are 3 caterpillar make(capacity:(1) 3.3KV,2.5MW(2)3.3KV,2.5MW & (3)3.3KV,1.9MW) & 1 deutz make (capacity:11KV,3.8MW)gas engines utilised,all are running in paralell. There are three transformer utilised,(1) 6.25MVA,3.3KV/22KV,Impedence voltage:6.7% used for two generator,both are 2.5MW(2)5.5MVA,3.3KV/22KV,Impedence voltage:7.2% used for one generator of 2.5MW & (3) 5.5MVA,11KV/22KV,Impedence voltage:7.8% used for one generator of 2.5MW.all generator breakers capacity of 1250Amps. Sir,I want the details of fault level calculation of generator,transformer individually & for whole system. If you require any information from me.feel free for contact me sir.pl.send the answer of my question as the earliest as possible.
How does a battary stores charge in it? please explain in simple manner and in detail.thanks
Draw the equivalent circuit of crystal oscillator?
Why AC & DC capacitor are use in UPS ??????????????????
how the synchronizing is obtained at bus couplers in grid substation? (because there we cannot change the frequency in one of transmission lines like in generator synchronization)
