Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / raj kumar moudgil
CIRCUIT BREAKER IS A SWITCHING DEVICE WHICH CAN OPEN AND CLOSE THE CIRCUIT , DURING NORMAL AND ABNORMAL ( FAULT) CONDITION .
IT MAY BE ACB,VCB,OCB AND SF6 TYPE.
PROTECTION DEVICES ARE RELAYS WHICH GIVES COMMAND TO TRIP CKT OF C.B. WHEN FAULT OCCURS.
| Is This Answer Correct ? | 8 Yes | 0 No |
Post New Answer View All Answers
What is superposition theorem?
Can double compression glands be used with regular cables?
In a tap changing transformer where is the tap connected, is it connected in the primary side or secondary side?
Why the earth to phase voltage is high 250 compare to other two phases
why do motors burn out? I understand why adding parallel loads to a power source means more current moves through the circuit, and can destroy circuit elements by overheating. What about when you have a vaccuum cleaner intake flush against a floor, a room fan sitting directly against a wall, or a power drill trying to drill through something too hard?
I want to calculate how much capacitor we connect to maintain the unity power factor? Is there any formula? Pls give me the answer
What is DTR erection?
how to select energy meter? have any calculation?
In a carnot engine with an efficiency of 40%, the heat rejected to the sink at 27 C is 60 kJ, then the heat supplied in kJ to the engine by the sources is
can we install HT panel & LT panel side by side or how much clearance is required ?
Does magnetomonopoles exists? one maxwell equation strongly suggests no, but how about their existance in plasma?
What is the maximum number of swithes that can be connected in series up to down stream point in an LV Distribution system?
what is transient enclosure vltage , very fast transients, very fast transient over voltages
how we arrange the hv side with delta connection in case 33/11kv of transformer.
design a 3 bit synchronous and asynchronous counter using T- flipflop
