Interested to Buy Any Domain ? << Click Here >> for more details...
What are the loads considered when designing the Nut and
Bolts?
- 12 Answers
- 21196 Views
- I also Faced
- E-Mail Answers
Answer Posted / arun giri
axial tensional load and shear load
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
sir i have to face an interview for marine trainee engineer on 15 sept tell me some related questions which r genrally asked...
sir i appeared to bosch written test recently and i cleared it successfully.can u suggest me how the interview will be done ?is it technical or HR or both?how shall i prepare for it?i am very eager to work with and in fact it is my dream job suggest me how to grab the job.if you know tell what type books are prefer for preparation of intrview?
what should be sensor sensitivity of accelerometer in vibration? And what is the main difference between accelerometer and proximity sensors and others?
What are your specific job requirements in mechanical engineers?
If 320 grade Gear oil is used in a reduction gear box,what can be themaximum operating temperature of the gear box?
How is a submarine able to submerge and surface?
What causes cylinder liner-wear down?
How does hydraulics work?
i m a 1st year student my senior asks me 2 give intro wht will a impressive answer
What is the normal vacuum pressure in a steam turbine atmospheric condenser? What would cause the press to falls?
what is run out? how to calulate run out vaue.
What is the most economical spacing of buttress ?
What is the percentage of carbon present in pig iron?
How the F.W.C. system of diesel engine circulate?
What does thermal diffusivity of metals signify.
