Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / raveendra nath
PI value is the ratio of insulation resistance at 10
minutes to the 1 minute value...
PI = IR(10 min) / IR (1 min)
For good insulation, PI >= 2
PI more than 1.5 is acceptable...
PI less than <1 indicates Bad insulation
| Is This Answer Correct ? | 8 Yes | 0 No |
Post New Answer View All Answers
what are the disadvantages in GIS over AIS
Why ground terminal is used in pot meter 10k ohms
i need the details about bhel exam.how to apply for that.please send to my email-id.thenmozhi2k7@gmail.com
What are the three major categories of error?
can i use 2000/5A Clamp meter to measure HT cable
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
what is the Earth Voltages in Power Plants, Sub-stations, Industries, Residential & Commercial Buildings.
Rules and standards of electrical control wiring ?
define as synchronous generator
If the Brush of DC motor is shifted by 90 deg, then what happens to voltage and torque? Both voltage and torque are zero. how to justify the answer?
what is the difference between gas group b and gas group c electrical equipment construction wise?
what is difference between isolation and ultra isolation transformer?, what is the method of testing ?
what is the function of statics switch in ups and tell me parts
Where is the best place to mount distribution panel in a house.
Briefly define and explain the following different types of Pulse Amplitude Modulation (PAM) with some examples. i) 2-PAM ii) 4-PAM iii) 8-PAM iv) 16-PAM v) Quadrature Amplitude Modulation (QAM)
