Interested to Buy Any Domain ? << Click Here >> for more details...
Why material of brush is carbon in motors why not other
material.
- 5 Answers
- 9731 Views
- NTPC, I also Faced
- E-Mail Answers
Answer Posted / ahammed
In carbon brushes, since, its like a semicconducting
material, the resistance of which is depends on area of
contact. Its used to reduce sparking & to avoid short
circuit in armature segments.
| Is This Answer Correct ? | 8 Yes | 6 No |
Post New Answer View All Answers
what is the difference between fault current ant short circuit current?
How to measure current and voltage in an ELV circuit
What is limitedly stable system?
What are the Full Forms of TVM, MTL, CVT ?
what is the function of choke in the flourcent tube lights and why the colour is in white mostly in flourcent tube lights
What is the maximum and minimum rating of UPS?
CAN WE CALCULATE THE NEGATIVE SEQUENCE AND ZERO SEQUENCE REACTANCE OF A GENERATOR USING ONLY ITS RATED VOLTAGE, KW, PF AND SYNCHRONOUS REACTANCE??? IF YES, THEN HOW??
Single line diagram for dbb (double bus bar)system.
stand by earth fault protection (51G) for transformer rating 2000 kVA,Dyn11,33/0.400 V. LV NCT ratio and necessary resistor and metrosil values how to calculate
What is oscillator circuit?
The D.C. spark test is applicable to single conductor cable & assemblies of insulated single conductor cables without insulation shield,metallic sheath or metalic armor?
How do i perform grounding of star point of Genset (400V) for making connection with step up transformer of DELTA-DELTA (400V to 20KV) ? while Genset itself has its own neutral and grounding bus bar inside genset breaker box whereas we have another neutral and grounding busbar in synchronizing panel next to genset at maximum distance of 6meter, would someone pls advice if we can only perform neutral grounding in synchronizing panel or should we ground neutral on both places inside genset breaker box and synchronizing panel.
what size steel armoured cable is required to support 1500kva capacity. would 70mm squared be enough or would I need 90 or 120mm squared 3c plus earth
explanation of mesh bus bars
Why back emf used for a dc motor? Highlight its significance.
