Why LT cables are not sized based on short circuit capacity.
- 3 Answers
- 4932 Views
- I also Faced
- E-Mail Answers
Answer Posted / s c budhiraja
Short Circuit fault levels of LT systems are low & all LT
cables can bear short Circuit faults. But problem with the
LT cables is of voltage drop.For this voltage drop
calcultions are done to see if the voltage drop is within
the permissible limit for the selected lenght of cable
being used for the rquired current.
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
What does the letter CTNM in negative phase sequence relay means?
Define cut-off rate?
to hook up ten 50 amp rv pedastels at a lenth of 600 feet from the service what size will my service need to be and the size of wire will I have to run to each pedastel in series??????
Explain the method to keep noises low in a control system?
what is draiv work
Why PT voltages are measured with respect to ground? What do u mean by voltage or current polarized.
What is depreciation factor?
Why in ESP Positive earthed
rajha power sector details
what about electrical pannel.? What is meant by plc pannel.?
DG Earth Value?
What happened if C.T mount at any cable or Bus bar in wrong direction . C.T going on proper work or not . C,T direction is essential thing to properly work.
what is RFCT and Insulgard Relay & It's function?
Details about Flux Compensated magnetic Amplifer starter for motors
WHY MOSTLY Rph IS USED FOR CONTROL CIRCUITS AUX. SUPPLY ?
