Interested to Buy Any Domain ? << Click Here >> for more details...
why contactors are used ...? is contactors and relays are
same ...?
- 5 Answers
- 11886 Views
- I also Faced
- E-Mail Answers
Answer Posted / kishor mochi
it is depend only load and load current.
if connected load is less then 5A,that case we are use
relay.
Exactly opposite side, if connected load equal lot grater
then 5A, that case we are use contactor.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
What are the advantages & disadvantages of a group electrive drive?
diff. between tension mode & speed mode
why the protection turbo generators is most complex?
How a capacitor discharge weld power supply works? what is the use of a pulse transformer?
HOW TO WORK A VFD?SAY SIMPLE METHOD
What is the percentage loss for aluminium wire for HT line more than 11KVa
What products have you designed which have entered high volume production?
what is the ms flat constant for calculating earth mat design calculation?
A 100KVA SINGLE PHASE TRANSFORMER 10000/200V,50HZ REQUIRES 300V AT HV SIDE TO CIRCULATE FULL LOAD CURRENT WITH LV SHORT CIRCUITED.THE INTAKE IS 1000W.THE % OF REGULATION ON FULL LOAD AT 0.8 PF LAGGING WILL BE HOW MUCH AND THE SECONDARY TERMINAL VOLTAGE ON 0.8 PF LEADING WILL BE
Draw a 230kv two-bus bar system showing the following. 1.Two generators (150MW) each connected through one 15.75/230KV transformers 2. 1 outgoing lines 3. Two 230/130 KV transformers 4. BUS PT's 5. CT
What is the magnetic field (coil DC ) of Turbo Expander?
EXPLAIN WHY THE SURGE CURRENT RATING OF AN MCCB OR CIRCUIT BREAKER DECREASES WITH INCREASE IN THE RATING OF MCCB OR CIRCUIT BREAKER.
how to set relay setting? and example calculation...
Why are cables rated for 40 KA for 0.25 Sec fault current rating?
How many gap between finger contact in a.c.b. and v.cb.?
