Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / bhaskar halder
D means delta
Y means star
N means neutral
DYN 11 means phase difference between 30 degree HV & LV
side (& vice versa ).DYN 11 TRANSFORMER loss is very low
because phase difference is minimum but it is not use for
higher rating because phase angle is very minimum so HV &LV
side are shrot to each other.so very higher rating use DYN
5 & DYN 6
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
I have a drawing of a wound rotor induction motor for a crane. This crane motor has 5 forward speeds & 5 reverse speed implemented of course with different amount of resistance for each speed setting selected. What has got me scratching around is the fact that 8 of the 10 speed selections switch in uneven (unbalanced) amounts of resistances on each of the 3 connections to the motor's rotor.Can this be possible? I would have assumed this would produce unbalanced rotor currents and therefore vibration in the motor. I would greatly appreciate anyone's comments on this. Many thanks, Confused.
What will be the effect of circulating current in HT xlpe cable when both the armour ends are grounded. Will the termination fils after some time in case of 33 kv supply.
Can you explain about pole discrepancy scheme
how to changeover ups in this power failur time?
Sir pl provide 5 year sample paper for post junior engineer(electrical).I have currently applied for junior engineer (electrical) on RRB Ajmer
send me all basic electrical question and answers
Comparision of Air break circuit breaker, SF6 Circuit breaker and vacuum circuit breaker.
WHY EARTHING NOT NEEDED IN BATTERY IN SUBSTATION
armature is that part in which current is induced since in dc motor we supply current to the conductor so why we call it armature?
On what principle electric motor works?
Give details of your interested designation, the post you are interested to serve the company better and explain why you think you can serve the company better in such position if employed?
what is the problem when i want to close a circuit breaker by local position it closes well.but when i close it in remote position it trips
can mini-curcuit supply MIL-tested transformer !
