Answer Posted / ch amir islam
Normally we use the CVs that have thier bench set more than
3 to 15 PSI but some time at low pressure line we use CVs
that have bench set of 3 to 15 PSI so we use the i/p of a
possitioner as o/p for traveling of CV but in normal cases
we dnt have i/p of possitioner below than 15 PSI.
| Is This Answer Correct ? | 1 Yes | 6 No |
Post New Answer View All Answers
Whatis the reset ofset and control system in instrumentation
how do i tune dearator pr control valve using PID. we set the set point is 0.6kg/cm2 now i want 0.5 to 0.7kg/cm2 limits so what should i give p,i,d values. then pls explain how do set pid values for control valve tuning?
how 3 out of 2 Logic/interlocks works? give brief explanation with help of diagram.
Q1: Consider part of a control loop, which excludes the transmitter, consisting of a process, a controller and a control valve which may be represented by two dead times of 0.5 min each and three exponential lags of 0.8 min., 1.0 min. and 1.5 min. respectively. We wish to express this system as an overall first order plus dead time (FOPLD) model ie gain, time constant and process dead time. (We will see later that this is often done, to simplify controller tuning). For this exercise, gain is considered to be 1.0. (A) If the transmitter is a flow transmitter whose behaviour can be described by a dead time of 0.2 min. and an exponential lag of 0.5 min. in terms of the overall dead time and overall first order lag how can the system behaviour be approximated ? Overall dead time = Overall time constant = (B) If the transmitter is a temperature transmitter with a temperature sensor in a protecting well whose behaviour can be described by a dead time of 0.7 min. and an exponential lag of 15 min. how can the overall system behaviour be approximated now? Overall dead time = Overall time constant =
Punj lloyd is coming in our Jadavpur Universtiy campus for campus placement. Please send me some hints about the writtend exam. My email id is subratafriends@gmail.com
When doing a liquid seal on a differential flow transmitter , most of the time the sealing liquid will be heavier then the process fluid. For wich application will the sealing liquid be lighter than the process fluid if transmitter is mounted below the process line.
which processor is used in dcs.
How to calibrate radar type level transmitter for interface level? Total liquid(liq.1 and liq.2), level both the liq individually? For. Both the liquid levels how the signal will go from transmitter to dcs? How to calibrate. Single radar 9:26:55 AM for 2 different liquids in a tank?
How we can check the 2 wire proxy switch? & how it is connected to DI MODULE OF PLC?
why direct mounted pressure transmitters is always installed with DBB ( double bleed block) valve in process line or top of the tanks ?
why we are using drum level control valve air to close?
In which principles tx ,pressure gauge,Temp gauge,control valve works?
Describe the functions of the Operator Interface including the considerations related to alarming and display layout/configuration/layers.
What is first echo & echo window in radar type level transmitter?
where uses EXe /EXd/Exo/Exn/Exp/Exq/EXia
