Answer Posted / dheeraj sharma
yes silica gel is used in transformer for absorved the
moisture from the air.
| Is This Answer Correct ? | 13 Yes | 3 No |
Post New Answer View All Answers
plz send me the procedure and syllabus for mseb exam
what is the minimum requirement gigaohms for the insulation test using 5kv in 300mm xlpe cable
What is the disadvantage in proportional controller?
how to deside the capacity of chock for drive?
what is feed back and what are feed back amplifiers?
WHAT ARE THE DISADTAGES OF SINGLE-WIRE-EARTH-RETURN SYSTEM USED FOR RURAL ELECTRIFICATION?
Can anyone tell the proper diagram of star delta starter????
Explain how you intend to work under pressure to meet up with deadline target?
which protection function should measure RMS value of current&DFT value of current?
In Dyn11 power transformer if any one of the 3 phases connected to earth in star connected side then please explain effect of the current flow in delta connected side of transformer.(In this case if one phase is shorted to ground in star connected side then we observe the current flow in two phases only not three phases in delta connected primary side. Please explain why it is so?)
which type of stability limit is higher,steady state or transient? why?
how to copy from plc ge fanuc versamax series,all input and output, adress, and printout.
What will be the effect of circulating current in HT xlpe cable when both the armour ends are grounded. Will the termination fils after some time in case of 33 kv supply.
Both generator parallel condition shared load equally but one genrator taking ampere more than the other what are all the causes to make like this
When we need up only in o/p 440v, so why we use directly in 11kva in input?