Answer Posted / k.prakashchandra
The output power is mechanical and not electrical.
| Is This Answer Correct ? | 3 Yes | 4 No |
Post New Answer View All Answers
What is the difference between alternator and generator?
In radial network the source is fed from 1 end both ends at central
Define conversion efficiency of a power amplifier.
what is difference between 2 pole structure and 4 pole structure in transformer yard
What happens if the negative to earth voltage is greater than positive to earth voltage in the battery of substation?
what is automatic voltage regulator?we can control the vlotage by using fuzzy controller in matlab?why we go for fuzzy?
Efficient electrical earthing in hard rock area
Show the schematic arrangement of diesel power station layout and give its principle of operation.
at meter room 50 hrc switch installed,but there are not get earthing proper,so what happen?and 11kv transformer out put going in to hrc main 400a three nog each? so earthing is require for all switch? (some customer made earthing at there home.)
How many methods use the load flow solution?
What are the factors influence the choice of an electrc drive?
Please brief working principle & construction of permanent magnet AC Servo motor
why does rotor rotets?
How to decide and select the different earthing wire size for the different types of earthing
What are the causes of having an rmu explode after installation? And how do u treat the bushings of an rmu?