Answer Posted / sudhi

30d

what is the metal ratio in granular subbase coarse for one cum ? And please explain the morth table ...what is the difference between grading 1 , 2, 3 what it means..plz explain

1837

---

what is the formula to find the sttel (bar)length in beam having bent up at l/4 t 45 degree & 60 degree.

2650

---

Calculation of Pier Cap with tapper area?

6386

---

What are your goals?

2993

---

SAND AND STONE AGGREGATES WASTAGE PERCENTAGE IN CONCRETING WORK?

2754

---

How to calculate the cement consumption in RR Masonry in CM 1:8 for the foundation of Ground Level Reservoir

1606

---

How to calculate volume of concrete & steel on tank foundation & ring wall ?

1632

---

In a beam,stirrups are placed closely at ends than at centre due to shear.similarly where would ties be closer to each other-at center or at ends in a column and slab.

3379

---

) Design a gussetted base for a column section consisting of one sc 250 with two cover plates 300 x 25 mm carrying an axial load of 2500 KN. The S.B.C. of soil is 250 KN/m2 and the permissible bearing pressure on concrete is 4000 KN.

2814

---

i have applied 40mm spacer in the concrete for tie beam. is it correct? kindly give me if there any code available

1973

---

significance of specific surface area of particles?

2306

---

What is min thickness,min grade of conc & age of PQC ?

9511

---

2. In a container filled with each of the following materials, at a porosity of 40%, determine the upward gradient required to cause the quick condition (a) Lead shot with a G = 13.75; (b) Fibre beads with G = 2.15; (c) Sand with a G = 2.32

2512

---

What are the uses of alloys in daily life and how are alloys made?

1376

---

What is zoning permit?

1255

---