15 suspects are rounded by the police and questioned about
a bank robbery. Only one of them is guilty. The suspects
are made to stand in a line and each person declares that
the person next to him on his right is guilty. The
rightmost person is not questioned. Which of the following
possibilities are true?
A. All the suspects are lying.
B. The leftmost suspect is guilty.
B only
- 2 Answers
- 10622 Views
- TCS, I also Faced
- E-Mail Answers
Answer Posted / akshay
Ans is B only since rightmost suspect is not questioned hence he is not lying and A is not true.
| Is This Answer Correct ? | 15 Yes | 9 No |
Post New Answer View All Answers
hello everybody. what does an abnormal stator winding impedance or dc resistance show? thanx
What do you mean by dependent and independent voltage sources?
An ELHNC 80amp 240v 30mA RCD is tripping periodically, every 30 - 180 seconds is it safe to disconnect the protection circuit?
What is the permissible maximum flux density in transformer core?
Differentiate between induced emf and self inductance?
i have applied for the post of RRB section engineering chennai board please send me previou papers and solved answer. my mail id jagarapusrinivas@gmail.com
what is the meaning of WYE and DELTA in Electric meter?
what are factors to be consider in electrical installation like load factor,diversity factor .....
difference between main metering kiosk and check metering kiosk
I am a electrical engg. diploma holder,applied for junior engineer (electrical),Kolkata RRB. Have I to attend all electrical,mechanical&civil portion in written exam.???
difference between Ac and Dc mcb ????
what is the voltage between earth & neutral in 3 phase electrical connection.
y we use neutral,all r told its used to for closed path..k its a just used to closed path,in a transmission line y we put same conductor used n both phase and neutral..if we use less than phase conductor in neutral mean we ll reduce cost its right r wrong..if we use mean any problem occur in transmission line..
Name the test signals used in control system
What is the difference between a verilog task and a verilog function?
