Interested to Buy Any Domain ? << Click Here >> for more details...
where Pirani gauges are uesd in case of pressure measurement?
- 3 Answers
- 7642 Views
- I also Faced
- E-Mail Answers
Answer Posted / manish kumar
For low pressure measurement around 0.01 pa to .1 pa
preassure can be measured by pirani gauge.
| Is This Answer Correct ? | 9 Yes | 1 No |
Post New Answer View All Answers
I have a Control VAlve having size of 2 ".Only the known parameter is Pressure drop . Its 2 Kg. Then How to calculate control valve sizing means Cv.
Whether the DI, DOs shields can be connected with Analog Input Shield Earthpit?
how to calibrate and troubleshooting of leveltroll?
the output of the common trasmitter protocol in qatar gas are the following
What is the difference bitween control net scaner and device net scaner
How is flow measured in square root?
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
what is the reason while warning lamp is on while the engine is cranking?
I want measure the volumetric flow of gas in waste heat recovery Boiler?Tell me how and which type of instruments required. Plz mail me:naba02222@gmail.com Sam please post the answer .
What is sensitivity in vibration probes..?
Drum level tx with GP4 with zero elevation:7300mmh20 on HP and 8050mmh2o on LP as range but on commissioning the tx readiing is max,Why this reading?
State four different types of flow measurement, for gas flow measurement MMSCFD is the common unit expand the unit and specify significance of word S in the unit.
how to change measuring units from mmwc to cubm/h in rosemount air flow transmitter with hart communicator fluke 744
what is the calibration procedure for transweigh make weigh feeder?
hi my name is rakesh patel i just complited my be in instrumentation & control now i am going to working as a validation engineer in a poject department so what is a scope in a future as a validation engginer ? what line is good for me can any bady give me complete solution please? your regard rakesh patel
