I want to measure resistance between Neutro and earth
conductor for 3 phase Transformer what should i do
- 1 Answers
- 3108 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
The resistance is infinity if the TR secondary neutral is
not earthed and it is zero if you use the same earth
conductor for Tr neutral earthing also. Further if you have
separate earthings for TR neutral and the earth conductor
,the resistance measured would be the sum of their ER
values, ignoring resistance of the conductors
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How to measure power in 2 or 4 or n phase circuit? Please give me a formula.
Why do we need interlocking in a HT metering or Ring main unit switchgear?
What type of a DC motor would you use for a lift?
why output is out of phase in case of common emitter?
Can u Explain about the electronic trivector meter and the use of data converters in them?
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT-SWITCH BOARD,MLDB,ACB,BUSBAR,ETC,......?
any application of back emf
salam,hi, i need to know what the spesification of 300amp msb...
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating)?
A commercial Building is designed with 14th floor levels with indoor substation of three phase transformer with rated capacity of 1000 Kva.The transformer delivered 65% of its rated capacity at 0.67 power factor lagging.Because of low power factor, the power customer was penalized and certain cost was charged accordingly based on every point percentage lower than 85%.This situation may repeatedly happen on the succeding energy bills of power customer.The power customer is desired to improve its historical power factor of 0.67 lagging and no further penalty be impose by the local power company on the next bill. Q: Identify the appropriate solution you want to offer to Client?.Justify SCIENTIFICALLY and MATHEMATICALLY the principles behind the solution.
If 22 KV HT line, Current transformer is 25/5 then how to calculate multiplying factor.
why dc is used in control circuit for mv & hv switchgear instead of ac
WHAT IS THE MEANING OF BALANCED / UNBALANCED IN STABILIZER TYPES.
Why magnetic flux produces an induced current?? what is the detailed procedure ?? ans plz
In the N-series schneider reclosers. What is the difference between current during fault time and current at tripping? This appears in the Event log in an event of a trip out.
