why 400Hz is used for aircraft systems ?
Answer Posted / ashish yadav
IN A AITCRAFT SPACE SAVING IS IMPORTANT, BY USING A 400 HZ FREQ THE SIZE OF MOTOR, GENERATOR, ALTERNATOR & TRANSFORMER SIZE CAN REDUCED BECAUSE SPEED IS DIRECTLY PROPORTIONAL TO FREQ AND INVERSELY PROPORTIONAL TO FLUX THERFORE FLUX IS INVER TO FREQ.HIGHER THE FREQ LESSER THE FLUX AND LESSER THE CORE SIZE MEANS LESS WEIGHT AND SIZE.
ALSO 400 HZ IS A CRITICAL FREQ ABOVE WHICH CONDUCTOR SHOW SKIN EFFECT MEANS START RADIATING, THIS AFFECT THE RADIO SYSTEM PERFORMANCE.
Is This Answer Correct ? | 46 Yes | 3 No |
Post New Answer View All Answers
what is the use of piston rings in the engine used for a generator...........
when we have to use UPF wattmeter and LPF wattmeter? what is the difference between UPF and LPF wattmeter in terms of construction?
in control panel, how can i measuring the distance between one bus bar to another bus bar. then now only for bus bar. in mpcb and contactor also. that means one mpcb to another mpcb how much distance? how can i calculate that.
what is ground fault in ACB?
why do we have spikes enough to burn electronic boards, when generators are not grounded
what is the standard values(Megger test) of resistances between L&N,L&E and N&E for a system on IEE regulations?
What is the maximum number of swithes that can be connected in series up to down stream point in an LV Distribution system?
1. Can a 12v DC choke operate a 60v/12w PL lamp ? 2. Can a 230v ballast fire / operate a 60v/12w PL lamps.
State kirchoff current law?
explain me the relation between torque, frequency,speed,voltage and current in the 3 phase induction motor?
What is servo motor? what is its purpose?
What are the advantages of using distance protection schemes as opposed to normal overcurrent/ earth fault protection on high voltage feeders.
Can you used moeller lzm1 mccb in a dc system with 125vdc and 20ka short circuit current , beside is it have 24 or 48 volt shunt ? Beside how long current can through from An MCB shunt contacts? (like Z7-AS 24 V)?
How much dc volt applied in cathodic protection system?
What is meant by celling voltage & current in excitor ?