Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / anil
due to magnetostriction and presence of harmonic components also
| Is This Answer Correct ? | 11 Yes | 0 No |
Post New Answer View All Answers
How do you calculate the actual power consumption of an inductive load appliance. Say, a deep freezer of 200watts
comparision between ACB and VCB
Hi My dear all Friends, There is a question regarding HVAC Engineering and widely used in Power Projects. Question- What is the diffrence Between REF, SEF and Differential Protection....???? Where REF - Restricted Earth Fault SEF - Senstive Earth Fault.
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
What is the emf equation of a transformer?
Define sensitivity?
how will we calculate the copper wire load..
What would cause a 240v choke that should give 110v out on a 16w lamp to gradually increase to 160v?
For the requirement of a furnace of temperature range up to 1200 oC using silicon carbide rods, What is the required rate of transformer needed (please do it with all details)?
what is meant by vector group of a transformer? How can it be derived?
How a band pass filter is constructed?
Hello sir i m student of gtu .what is idp.
Define characteristics impedance?
We have 90mX100m hangar with 16 no.of supporting pillar. It is required to provide power supply on all pillars. what is suggested earthing scheme for hangars.
what are the difference between PLC and embedded
