Interested to Buy Any Domain ? << Click Here >> for more details...
what the reson to use phase shift( angle) like (dyn11,Dd5
or Dy0)are usedin power and transsmison line
- 1 Answers
- 4935 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
Dd5 and Dy0 are not possible.When primary and secondary are
connected in different groups ,there will be inevitable
phase shifting. However Dd6 and Yy6 are possible.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
what about GD square and its important for motor design?
Define non-touching loop.
What are the symptoms of a bad PG card of a drive (inverter) esp. of Yaskawa Ac Drives (inverters) G7 ?
what is stper motor
What are test signals and their significance?
we have consol make 3 phase servo stabilizer for cnc m/c. while installing the earth neutral voltage is 1.7 volts at stbilizer off condition and when stabilizer get on en voltage reaches 4.8 volts (new earthing is done and neutral is helthy condition all phase to neutral volts 440,442,441 v)why this happen.solution for cause.
send me all basic electrical question and answers
What are the section criteria for cables. Now everywhere XLPE power cable is used or PVC is also used?.
How to find out damper winding failure for synchronous machine?
what is inverter and converter
What are conduct on the testing in cf in ur site?
Hi, Next week Iam appearing RRB exam for section engineer. So help me to get modal question papers for this position. Iam very thankful to you. Whether question will be fully techanical format or general form. Please give me a details regarding this exam.
What are the basic & Majour problems in UPS ?
Please clarify, 1. Is it required to lay two runs of GI wire along with Armoured LT cable if it is laid between one big mains (63Amps TPN SDF) to small main (32A TPN SDF) with proper glanding termination? 2. If the armoured cable with proper glanding is laid from DB to CNC machine, is it required to run two runs of body earthing to the Machine from DB? 3.If the armoured cable with proper glanding is laid from Substation to Hangar, distance is approx. 100 mtrs, is it required to do earthing at shop area though the primary termination at substation is earthed through gland.
what will happen if synchronous machine rotor fed from single phase ac supply
