Interested to Buy Any Domain ? << Click Here >> for more details...
what is MFD value in capacitor?I have 201 Kva load &
reactive power is 150 Kvar. so how it is calculated?
- 2 Answers
- 9387 Views
- IIT, I also Faced
- E-Mail Answers
Answer Posted / joel
1 volts
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
11kV capacitor bank of rating 2.4KVAR, is charged with protective relays of only over current & Earth fault &.......without Over Voltage, Under Voltage & Neutral Displacement Relay. Is it advisable??
Any one who apply for Ferro Scrap Nigam Limited cn join with me at rajuhalder@indiatimes.com or 09669717028
Hi.. I am a BE GRaduate in E&E. I have 8.5 Experience in Tendering & Estimation field. I have done SAP SD course few years back. But due to some reason i failed to get job in that field and continued my own field. Now I am thinking of changing into SAP seriously. How should i go ahead???
What is FTA card? How it works?
How wire size can define in electrical wiring? What is the ratio?
7- What is the Dissipation Factor and the difference between it and Insulation Resistance Test? 8- What is the task (function) of DC and AC reactors in power plant? 9- What is the task (function) of (open delta with earthed) in some types in transformers? 10- What is the base of the selection of the vector group in transformers? 11- What is the zig-zag transformer and its function by drawing in large detail? 12- What is the polarity ? 13- Why we make short between phase(R) in high side and phase (r) in low side in vector group test? Where High Side ( R ,S and T ) and Low Side ( r ,s and t ). 14- What are the time on delay and time off delay? 15- What is the vector group? 15- What is the task (function) of different types of vector group such as Dyn11 , Dd0 , YNd1,……..,?
why chock were used in old tubelights but are not newest tubelights?
Post possible questions for Power Factor Panel FAT / SAT
Is there a standard depth of gravel fill in Substation Switchyard? Please give a design/drawing. Thank you.
Load transfer in 11kv double busbar switchgear - operation.
Why saturation region slowly shifted in the left side?
Could Please Explain briefly. Why used stabilizing resistance series with High impedance bus differential protection relay.
Why electrical power generation and transmission done in 3 phase system not more than 3 phase ?
what is the function and use of cable differential protection relay?
Can we test the alignment of End shield and stator of turbogenerator without rotor insertion? Also how to fix maintain the alignment at site installation?
