Interested to Buy Any Domain ? << Click Here >> for more details...
can we connect 2.2kw star motor in delta passion?
- 1 Answers
- 4306 Views
- Zuari, I also Faced
- E-Mail Answers
Answer Posted / shailesh
Yes, You can but subject to voltage level. e.g. If you have
690V rated motor which is star connected.You can connect it
in delta for 415V system.
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
oil cooled transformer
How do i perform grounding of star point of Genset (400V) for making connection with step up transformer of DELTA-DELTA (400V to 20KV) ? while Genset itself has its own neutral and grounding bus bar inside genset breaker box whereas we have another neutral and grounding busbar in synchronizing panel next to genset at maximum distance of 6meter, would someone pls advice if we can only perform neutral grounding in synchronizing panel or should we ground neutral on both places inside genset breaker box and synchronizing panel.
If I have Energy Meter Ratio as 100:5 & Also I have CT Ratio as 50:5 then what will be my multiplying Factor(M.F.)
Why the moulded plug comes with domestic appliances instead of assembled plug like anchor, Vinay 5/15 A.
IF 8255 CONTROL WORD IS 94H,Tell the chip port work mode ?
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
i want to model paper for section engg.
why the voltage and current in a long transmission line are called travelling wave?
why 3 phase is converted into 2 phase using electronics circuit why not 2 phases are diresctly putted from the 3 phase transformer??
what is p.s impedance measurement test in earthing transformer?
what is mean by ideal infinite bus? why it is required to consider in fault short circuit calculations?
Can we check ELCB constantly from R1 to R8 phase in 1 no DB?
In electrical locomotive engines, the DC series motors is being used as traction motor. But in new engines like in WAP7 & WAG9 the 3-phase squiral cage induction motors has replaced them. So can someone tell me the advantages of induction motor over dc seris motor in engines points of view....???
What are the advantages of hydropower?
how we calculate the withstansing current capacity of wires&cables?
