Interested to Buy Any Domain ? << Click Here >> for more details...
What is a Single Phase and Three phase Power? How it will be
converted or transformed into another form?
- 3 Answers
- 8404 Views
- I also Faced
- E-Mail Answers
Answer Posted / pravin patil, amol, aher
Single phase means 230 V 50 Hz Power supply & 3 Phase means
415 V, 50Hz, For converting into another form like
mechanical or Heat Energy,Magnetic Energy.
| Is This Answer Correct ? | 3 Yes | 7 No |
Post New Answer View All Answers
why the voltage and current in a long transmission line are called travelling wave?
In Dyn11 power transformer if any one of the 3 phases connected to earth in star connected side then please explain effect of the current flow in delta connected side of transformer.(In this case if one phase is shorted to ground in star connected side then we observe the current flow in two phases only not three phases in delta connected primary side. Please explain why it is so?)
How can we find the breaking capacity of a Load breaker switch (LBS) fed from 11 kv supply??ex:50KA, 26kA etc???detailed step vice answer pls.
Dear all, I want to use Induction motor to open and close a 1 ton door. How much power do I need. Thanks
how to CHECK CT AND PT AT THE FAULT OCCUR IN GENERATOR RELAY PANEL .
should %impedance be high or low in a power transformer? if so why?
how to calculte capacitor range for single phase induction motors??pls tel
What is the end effect of linear induction motor ??
How to synchronization will be done between two DGs ?
What will happen if the d.c. Shunt motor opened accidentally running on no-load has its shunt field winding?
we have earthmat at 110KV substation.we would like to take earth resistance.b some says that by connecting earth megger terminals (C1,P1) at middile point of earthmat (at riser) will cause voltage gradient at other earthmat nods and dont get exat earth resistance.when connecting at end nods will get exat value . is it correct .please explain
What is s-domain and its significance?
why should small green grass ans small plant should not be there inside the transformer Yard in the factories
what is the reactance,capacitance & impedence electrical armoured & unarmored Cables.
can I improve the furnace power factor (10 mva transformer) by adding a capacitor bank before the transformer.Does system power factor vary a lot with the furnace PF?
