Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / mrmk
At Lowest temperature area applications.(Below 0 Deg Cent)
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
Working principle of magnetic flow meter ......and calibration procedure of e+h magnetic flowmeter...
Pressure tx shows 1 mbar but we need 1000 mbar at this process condition .. how can we sort it out .
How ejector(or)evactor air pump is working in thermal power plant?
Specify eight technical requirements that you would consider important, when deciding upon a particular control valve?
what is interlock system and why we use of this?
What inherent design and operating principles are included in a modern control system to use predictive maintenance practices to increase overall system reliability?
What is the main difference between Cavitation and Flashing?
In dcs panel we are using diff type of modules ?what is module ? what is the use of modules ?diff type of module?
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
How to find out the current of two motors having same power consumption but different RPM?
principle of automatic votage regulator
Draw a P& ID showing – orifice flange, plate, dp transmitter, isolation & bypass valves and tubing.
where are following valves are applicable to install. can any valve be installed any line. globe valve butterfly valve boll valve gate valve
What is difference between “Fault Tolerant” & “Fault avoidance” PLC? Application where these system s are used?
explain key exchanges in all security modes WPA,WPA2,TLS?
