pressure switch range 0 to 2bar.i have to install from
ground level to 5 meters height.what is the formula the to
increse the range ? and every 1 meter how much pressure
should be add ?
Answer Posted / mrmk
It depends upon the tapping point.In your case if the
tapping point is at ground level and pressure switch
installed above ground level then no need of any
compensation.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
how to design orifice plate?what is the equation?
what effects a surging can produce in the compressor
what is o2 analyzer and how it measured ,what is the role of this analyzer in cfbc boiler...
Explain types of valves?
I m appointed as an automation trainee engineer in small firm in that I am only the one , my company give me a project on s7-200 as i m beginner I don't know how to program so please send me the helpful site so that I complete my project before deadline....please help me out in this critical situation.
How to calibrate Toxic gas detector?
Name different types of bourdon tubes.
in differential pressure transmitter,min&max pressure range for hp&lp
NPN transistor, SCR, Zener diode, LED, Varactor diode, Vortex meter, RTD, Resistor, Crystal
Can anybody tell me how to select the size of earthing cable for DCS & PLC system.Please tell me any relevant answer here or mail it to me.
why we use cascade control and feed foreword control in 3 element control of boiler drum ?what is feed forward and cascade control system ?
How many are the types of instrument cables in terms of No. of pair.
what is difference between fork type and capacitance type level switch. where it is using
Why do we have earthing cable in branch cable and shield in the same cable?
Dear Friends, we are planning to design Power distribution and Fiber optic in the same cabinet.Like Front side Fiber optic and Rear side Power distribution.Is it any possibility of problem occurs like interference etc? Your answer is highly appreciate.