what is the all safty name of diesel genrator?
- 2 Answers
- 4384 Views
- Adani, I also Faced
- E-Mail Answers
Answer Posted / manish chaudhary
safety of dg set:- 1- low lube oil preesure
2- high coolant temp.
3- overspeed.
| Is This Answer Correct ? | 7 Yes | 2 No |
Post New Answer View All Answers
what is Fan Control Cubicle
From what on-site components does the HT panel monitoring the bus-bars in a 11kV system take inputs?
why to use freewheeling diode ( diode in revers bias mode) across dc coil
why we take movement of rotor always in counter-clockwise direction in 3-phase induction motors?
How can we calculate ac current from the given DC current when AC voltage is given?
What is the working principle of servo motor? And explain it.
what is data block in plc ? How the values of data block are written and read by hmi ? what is the difference between function and function block ?
IF alternator SCR value will be high means what happen in alternator efficency at operating power factor of 0.8
Which are resistive loads & which one are inductive loads : Refrigerator, Split air conditioner, ceiling fans, well pump, fluoresecent bulbs, T.V, CRT Monitors, Adsl Routers, C.P.U, Printers, Deep Freezers, Speakers, DVD Players, Microwave oven etc. ? Output Power for these Appliances Would be same like this : P = V * A * P.F Or would be changed ? thanks
What is the difference between a verilog task and verilog function?
I need to connect a synchronous generator to the grid using automatic synchronization and two circuit breakers (one for synchronization, one for end connection to the grid), how to determinate the required diameter of the cables?
Why there are some equipment(i.e:TV) that using 2-pin plug instead of three? What happen if there is current leakage? Are we going to get electric shock??
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
dg earth connect only in the amf panel or not why
Hi Friend I am used multimeter to measure the voltage between R Phase(SS1) to R Phase(SS2). In SS1 is connected with UPS loads. But I am getting voltage between these 2 R Phases. Please give some idea friend
