Answer Posted / thanush
The generator start in the full load. All motors are running
in maximum speed and load ,so calculate and test the KW meter.
| Is This Answer Correct ? | 4 Yes | 3 No |
Post New Answer View All Answers
Explain what cmos is and its benefits?
How select ELCB for 32amp. socket having quantity 12Nos. We have to do this wiring in PLANT. Please Also explain the incoming cable specification.
determine two methods to find loose connection in operational electrical system?
r we are using in gas turbine mark (5) frame (6) (made in india Bhel 1997) Ā
How to select the earthing transformer,for DELTA TO DELTA TRANSFORMER OR ALTERNATOR SIDE.Pls post your answers and calculation.
What happens when two positively charged material is placed together?
We have 250 KW x 2 motors, which are load from 25% to 100% varying load in every minute , so how can we compansate the power factor. pl give your opinions on the above subject.
what is the responsibility of C license holder in industry?
Is there any relevant technique to produce power from light and heat energy of the sun simultaneosly from same rays of light?
earth also having a gravitational force (magnetic field of north and south)but it attracts any object compare to this theartifical magnetic cant perform same as earth why?
I want formula to calculate cable size as per load given in length & amp. I searched many sites but didn't right answer. Please reply me asap.
How to test the vector group of a Yd11 transformer? what are the relations to be checked between various vectors to confirm this vector group?
how to find out cable size if load is 2800 watts, 230 volts AC supply and load distance is 1800 meters
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
How to calculate the copper in HT motors if KW, RPM & Voltage is given
