How much ampere rating on LT side of distribution
transformer and also on HT side of 200KVA transformer
- 2 Answers
- 11509 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / nirmit
Just Forgot HT LT here i give formula for amp
If 66000v KVA/114180*1000= found amp
11000v kva/19030*1000
440v kva/717.95
how
kva=route3*v*i
1.73*66000*i
114180*i
2000=114180*i
i=2000/114180
=0.0175*1000
=17.15 amp at 66000v
| Is This Answer Correct ? | 5 Yes | 4 No |
Post New Answer View All Answers
how to find ratio of CT & PT in 66/11kv 12 mva supply system ? explain with calculation.
what is the meaning of WYE and DELTA in Electric meter?
WHAT IS MEANING OF Gg & Gg IN hrc FUSE
1 “earthing” for bonding of equipment and circuits to common plant earth electrode potential, 2 “protective earthing (PE)” when this bonding is required for personal safety provisions 3 “grounding” for interference suppressing bonding of screens, sys-tems with ground level 4. low-impedance earthing ? 5.primary earthing system and secondary earthing system what is that? 6.earthing electrode or mesh net earthing electrode ? very confusing , simple but very informative help required ? i will be very very thankful to you guys.
A 10 MVA, 66KV, 50Hz, Y-connected 3-phase alternator has synchronous reactance of 0.635 Ù. It is working at full load at 0.8 lagging p.f. condition. Find torque angle, neglect armature resistance.
Can 33kva/415v transformer be run underground? If the answer is yes why and if the answer is no why?
On Which Pressure PRV is operated.
what is difference between window type and wound type transformers?where we will use window type and wound type transformers?
Percentage losses in power generation?
How Load Factor, Demand Factor, Diversity Factor etc best applied in designing an electrical circuit? Is it allowed to consider these factors in each and every panel in an electrical distribution system? Can any body suggest a good book for reference?
What is the difference between the impedance percent and impedance voltage ?
what is the safety of voltage power transformer(2250KVA0
a 230v transformer with step down ratio 19:1.it has 2000turns on primary and rated 25va calculate max primary current no of secondary turns volts/turn
what is earth-fault?when it occurs? to check where it occurs what type of test should we do?
How to calculate loses in transformer of 160 KVA ?
