Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / chandra
power factor gives us a measure of the energy that is stored
in the capacitors and inductors.Inductors and capacitors
doesn't dissipate energy but,they constantly gets charged
and discharged.So,the whole power transmitted by the power
company doesn't go the customers.i.e,they can't utilize the
maximum power capability of the line.
Power factor is also important in
calculating bus voltages in a load flow problem.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Load break swicth maintenance procedure.
I am shobana from Chennai. I am having my personal interview on 19th Dec at Chennai.kindly mail me the questions to mail id shobana.shanthi@gmail.com
what is the necessary of using inductance property in transmission lines even through resistance is used to opposes the high current flows in that?????
brief notes on ammeters
DRAW ACIRCUIT DIAGRAM OF 100 KVA 415V/55-0-55V DELTA TO STAR TRANSFORMER
How to back charge the Gas turbine generator
What is the Designing & Selection Procedure for a DG/Transormer of rated capacity?
what is meant by moulded case circuit breaker ?
What is the use for cable entry in control room?
Is there chopping current in resistive circuit
When semiconductor fuse does save thyristor in each cycle of conduction? Why under voltage setting keep less in SPRS and more in DC drive?
What is the need of earthing transformer for delta side of a transformer. (Think of a line section between a star/delta transformer at a grid substation and delta/star transformer at a village. An earthing transformer is there at the delta side of the star/delta transformer at grid substation). As there are no ground reference there will not be fault current if a one phase is grounded. Further L-L phase will be sensed by the primary side of star/delta transformer as a L-G fault. So why an earthing transformer is required at delta side
What size cable (based on voltage drop) is required to supply a 40 A three phase boiler if the wiring system is 75V single insulated cables installed in non-metallic rigid conduit 56m from the main switchboard? Voltage drop in the consumer's mains is 8V.
why electronic instruments is more favorable than electrical?
In ups static switch if i gives the supply at output end it will open the circuit in stactic switch or not if it will open then how it operates.
