Interested to Buy Any Domain ? << Click Here >> for more details...
Which two commands show your access lists? (Choose two)
A. show filters
B. show access-lists
C. show ip access-lists
D. show running-config
- 2 Answers
- 4389 Views
- I also Faced
- E-Mail Answers
Answer Posted / biswajit biswas, kolkata
sh access-lists : will tell you to view the entire contents
of all access lists
sh ip access-lists : will tell you on which porthave access
list applied
sh running-config : will also can be used to monitor access
list.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is DHCP stand for?
Explain the difference between collision domain and broadcast domain.
When ospf protocol advertise its routing table?
What is the difference between csma/cd?
Given the configuration example: interface ethernet0 ipx network 4a ipx access-group 800 out interface ethernet1 ipx network 3d interface ethernet2 ipx network tc access-list 800 permit 3d 4a Which action result from implementing this configuration? a-Traffic from network 3d for network 4a will be forwarded out e0 b-IPX network 5c will not receive any traffic c-Traffic from network 3d, destined for network 4a, will be forwarded out e2 d-Traffic from network 3d for network 3d will be forwarded out e0
Name the command we use for ping in ipv6?
What are the conversion steps of data encapsulation?
What is osi?
Hi Friend. i have to let you know that now i have been selected for cisco india in bangalore. i am thanking to all of you guys that u have been posted such good question and the respective answer. from today i will be not able to visit this site on regular basic and hopeing that you will continue to post the question.the question you are posting is not very usefull to you but also usefull to another. i am again thanking to all of you and hope for best for your feature. Jitendera kumar sinha Network engineer-L2 cisco india Bangalore
In which access- list type you can't do editing?
GUYS i was refraining the OLD post and i got a good Question and wana make sure that you guys Just did not vist it for answers if you are not Aware google it understand it and then answered it the question is -: Significance of IP helper-address Command on SW? Is it necessary to put this command? you donot wana to give answer please donot visit this question and increase the vistor name if you are thinking that answer is wrong mark it wrong and explain why you are marking it wrong
Is hub intelligent device?
Which cable called roll-over?
What is the meaning of synchronization?
What is difference between routing and routed protocols?
