Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / marimuthu
power factor is nothing but a loss of energy
power factor is ratio of real power and reactive power
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
I would like to know that the fault curretn at base load and at 10% generation will be same? Fault level of BUS remain same with different generation?
why steady state stability limit is greater than transient stability limit ? How it can be explained ?
1.Can we use 6.6/11KV 300sq mm xlpe 3core cable for LT use (415 Volt). 2. If we use it for LT then what is the current rating
When are the directional relays used?
Can i replace Earth leakage relay to the faulty Earth Faulty Relay
What kinds of decision are made about CT from it's Knee point(voltage & current)?
A system absorbs 100 k J of heat and the increase in its internal energy is 100 kJ; the work done is
how to find the voltage's of a transmission line plzz help with pictures i am not able to understand
what is the difference between rectifier and converter and commudator?
How should i design a 1ph & 3 ph transformer. Kindly let meknow all steps and formulaes related to design from scratch.
how to meas-our losses for L.T & H.T
How to measure current and voltage in an ELV circuit
dear sir/madam i want to get some knowledge about RRB EXAMINATION(section engineer) 1- what is minimum cut off 2- wht portion is major portion . 3- can any body provide Sample paper. thanks & regards ashish
WHY RATING OF VCB NOT LESS THAN 630A
percetans
