Interested to Buy Any Domain ? << Click Here >> for more details...
What happens when generator is running with leading power factor on it say -0.96. what are the effects of it on alternator and the other generators operating in parallel to it.
- 2 Answers
- 5844 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
Nothing.But it is better to run the GEN on lagging pf for
stability of system
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
what is breathing?
how to carry out Magnetizing Current Test on Distribution transformer and what purpose we are doing this test. why transformer rating in always in KVA ? what ispositive, negative, zero sequence impedence? How ElCB tripping if Neutral touch with ground Why AC & DC capacitor are use in UPS ? why motor rating in KW? how to syncronize two dg sets
Meter p.t. ratio= 3×230/400 , c.t.ratio = 3×1 (2) A what is m.f.
What should be the values of settling time, peak time, steady state error, overshoot, rise time, MPOS (Maximum percent over shoot) to keep the system in transient state, to keep the system in steady state ?
Define transfer function?
How will A Medium voltage circuit breaker(11 kV voltage level) operate under short circuit fault condition whether It is having short circuit release like Low voltage circuit breaker or relay should be given?
why dc is used in control circuit for mv & hv switchgear instead of ac
why normally Generator rating are between 11Kv to 22Kv?
although ckt breakers have taken the place of old fuse. But instead of it , these older ones are still used in the industries and homes ? why .... what are their advantages and disadvantages ? which one is leading and winning the race and competition ?
Why GRR starts from 60% of motor speed why not less than 60%?
bus bar design conditions and sizing pls tell me quickly
How to Calculate The Neutral Earth flat design calculation for the Synchronised generator (Gen 1-650Kva, Gen 2-725Kva
Is Transol transformer oil comparable to nynas nytro libra?
why can we use cosine wave instead of sine in ac supply as both have same rms vale and ripple factor
On 400 amp factory load how kvarh capacitors provide
