Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / vasudevan
An isolation transformer is used to isolate the primary and
secondary circuits.To protect the source equipment from any
voltage or earth fault in the load circuit.this transformer
mostly used in induction loads
| Is This Answer Correct ? | 17 Yes | 0 No |
Post New Answer View All Answers
What is the diffrence between ff tx and non ff tx
Sir, I want junior executive, Instrumentation question papaer for IOCL, Plz send to arabinda.ghosh83@gmail.com
What is three element in drum level?
give some question relative instrument fitter?
What is the use of each wire in three wire RTD
Can combine control system for Emergency control system (ESD)and Fire & Gas System ( F & G) is possble to built and offer to client? Can such system is as per Norms in India?
How is work 5/2 sov?
Describe the typical instrumentation used in monitoring the performance of a shell and tube heat exchanger.
Draw a simple circuit for a well head control panel used to protect the well against fire, leak, blockage, ESD, & controls the operation of one downhole & one surface safety valve. Explain the operation and controls
pls provide me syllabus and old question paper of instrumentation engineering for GET(JSPL)
can we replace a slot sensor (inductive type) with limit switch (potenial free contact / no-nc type).
in natural gas indirect water bath heater,how to prevent the problem of backfire from firetube during ignition...becoz of this backfire performance of wbh is going low.
How to work togather like sov,limit switch,proxy switch and booster in xv
Senior engineer's please help me, what is Loop Checking and Loop test? and write difference also? soon urgent
What is 1:1 redundancy ?
