Interested to Buy Any Domain ? << Click Here >> for more details...
why we are testing cables with DC supply not with AC supply?
- 9 Answers
- 31301 Views
- Aurobindo, DEWA, L&T, I also Faced
- E-Mail Answers
Answer Posted / guest
because no continuity in a.c. Power supply that y we r tested a cable with d.c. Supply
| Is This Answer Correct ? | 6 Yes | 11 No |
Post New Answer View All Answers
what is droop control?
What are the reasons for the parallel operation of transformers?
Dg pf .71 i am improve pf 0.80 what capacitor connected in dg how?
What is the formula for selecting the cabels according to load? How to calculate what sq.mm cabel to be used?
How to convert 2 phase to 3 phase electricpower in induction moter?
the grid connection required for a 50 MegaWatt fotovoltaic powerplant is higher or lower than 35kv (high or medium tension)?
In EHV transmission line a neutral grounding reactor is often placed at neutral point of shunt reactors. What is the recommended protection for this neutral grounding reactor? Should I use a fast closing switch to bypass neutral grounding reactor when this protection operates?
If I bring a basic electric meter from the States and hook it up in Costa Rica in a development that has only one transformer for the 50 homes, will it still be accurate regarding the usage of kilowatt hours?
what is the minimum pay scale for electrical engineer (building construction)in kuwait? plz revert back with yrs of experience & pay scale respectively.
How to distinguish whether MCB is DC or AC looking at it physically
What is the abbreviation of NGT panel
i am completed in B.E(Electrical and Electronics Engineering) with 8 months experience in Quality Control Engineer at Bharathi Industries,Coimbatore.
when we gave dc supply to 220v dc motor its rpm is 1200. then we gave 180v. how many rpm of its motor. gave answer with calculation at my ID.... ravizak@ymail.com
ii) A shunt motor supplied at 230V, runs at 900 rpm when the current is 30A. The resistance of the armature is 0.4 ohms. Calculate the resistance required in series with the armature to reduce the speed to 600 rpm, assuming that the armature current is then 20A. [12]
what is the minimum (Common factor) insulatin resistance of the following a, 4mm sq wire b, cable from 50 mm sq to 800mm sq
