What are the things needed to finish interview successfully
from the perspective of interviewee ?
- 5 Answers
- 6536 Views
- NTPC, I also Faced
- E-Mail Answers
Answer Posted / kishore338
to find your skils of different kind and estimate your
capabilities while you are in argument
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
"What do you do when in your duty, ME alarm oil mist detect high density?"
Which questions will be asked for mechanical design Engineer position in GE?? plz give me reply it's urgent...
Please tell about the water type h.v.a.c with it's cycle and functions of each parts ?show me how talented u r?
will I find the mechanical engineering interview question for asian paints?
What happens when too much cylinder oil is injected in the working cylinder?
What are the ASTM materials used to manufacture boilers?
If I can absorb 9,000 lux of sunlight in the bottom of a pool what will the temp rise be per hour, per square foot of absorbing material, per gallon be? Temp of pool deck 115 degrees, water temp 75 degrees, 120,000 lux on the pool deck
Maximum combustion temperature in gas turbines is of the order of 1100 to 10°c whereas same is around 00°c in i.c. Engine ? Why ?
why are using ahu?
When a 30KW/3 ph pump runs one hour continously, what will be the heat dissipated? how can i find this, any general equation?
junior engineeer (railway previous questions)
Dear all, Will some one help me in this issue please? We are entering the Zero Stock Component in Maintenance Order, and we make a Check when the order creator is going to release system will appear Error, until he will not delete that zero stock components from the Maintenance order. but right now what the order creator is not releasing the order but he is going to save order, when's he save the order without release system will generate Reservation in the back ground, which should not happen for Zero Stock Components ? I need the way which we are doing in MB21, Reservation creation by thru Cost Center / WBS Element. At present if you run MB21 and you are going to issue the material system will not allow to generate the reservation if there are zero stock components in the list. please guide me for this issue ? Note : Simple what I need is I don't want to create any reservation thru maintenance order for the Zero Stock Components. Regards, Abdul Mujeeb
What is view factor ?
Inspection for intermediate shaft bearing.
What ill be the shaft diameter with clearance having a bearing bore is 30mm?
