What is the basic principle of vibration measurement by
BENTLY NEVADA vibration measurement system? and Why it
gives the -ve voltage output?
- 14 Answers
- 131702 Views
- Ensol, GNFC, Reliance, Siemens, I also Faced
- E-Mail Answers
Answer Posted / pj
gr8 answer steve
| Is This Answer Correct ? | 15 Yes | 7 No |
Post New Answer View All Answers
why we use impulse line of flow transmitter at 45 deg. angle both side of orifice plate.
when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??
what is wave length were using ?
Explain plc level and its type?
Describe how to use megger to measure the earth resistance and insulation resistance
how to measure draft pressure in transmitter pl. give its single line digram
how many types of spped sensors n vibration sensors?their basic principle n connection?
how to relay switch sense the fault?
How to calibrate H2s Dectector
How to Calibrate Radar Level Transmitter in Field
how does we calibrate a square root flow transmitter ,give an example and explain it step by step like range calculation , calibration hook up series connection , zero check , and how to apply pressure , and if not geting proportional output then what should we do ?
i have done DAE in Instrumentation and Process Control. i have applied for an apprentice training in chemical company after three day my interview will be conduct but i need more information about industrial process control and controller. my e mail is imran_dilsetu@yahoo.com please tell me interview question relative to instrumentation ?
any one can send me instrumentation previous interview papers? I prepare for MNC Company Interviews? my mail id- Rakesh.Golla@dodsaldxb.ae , and another mail rakesh.gvk@gmail.com
what is the diffrence between pressure safety valve & pressure relief valve....pls
What is hp & mp seperator .& what is its working principle ?
