Interested to Buy Any Domain ? << Click Here >> for more details...
what is mapping in instrumentation and control engineering
- 2 Answers
- 6967 Views
- I also Faced
- E-Mail Answers
Answer Posted / fulbert
Mapping is either called I/O Mapping for configuring
Input/Output addresses between the devices in a control
system network.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
-/5A. What is the meaning and limitations of this in energy meter constant. It is a 3 phase LT Energy Meter. If this Energy Meter is connected through a CT of ratio 200/5 Amps, then what is the multiplying constant and how its will be calculated.
How to Calibrate Vortex Flow transmitter in field
Give 2 application of quartz crystal used for process parameter measurement.
What is 3 element control system
Can combine control system for Emergency control system (ESD)and Fire & Gas System ( F & G) is possble to built and offer to client? Can such system is as per Norms in India?
how will you check torque value during Factory acceptance Test for control valve/ESD ON/OFF VALE how will you confirm this torque value is being correct, Which document will you be refer.
what is use of communication wire in multipare cable(oil and gas field), why this communication wire not used in single pair cable?
What are the uses of orifice plates?
what is maxdna ?. explain about the software details.
How does your previous experience relate to the job you are applying for ?
basic connection and principle of axial shift sensor n differential sensors in tubine describes n draw......
all questions related to instrument technician in any offshore oil and gas company.
what are the selections available in configuring a burnout protection of a controller? thanks
How will you test a transistor with a multimeter?
i hav applied for the post of engg. in iocl so please require the past test papers fro instrumentation engg please please help me and send me the papers or tell me the pattern and type of ques asked in examination......
