Interested to Buy Any Domain ? << Click Here >> for more details...
kindly arrange to send me RRB Bangalore previous question
paper for JE/Electrical and JE/Signal I am going to write
exam on 2010
- 2 Answers
- 7209 Views
- I also Faced
- E-Mail Answers
Answer Posted / s.vasanthi
yes please kindly send rrb JE/Elrctrical question paper
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
How to improve fuel cell in a distribution system?
In CTs tan delta point should be earthed , what is the reason behind it?
Why L.T.Cable voltage rating is 1.1kV,where as system voltage is 0.415kV?
what is gridrotor resistance starter
Can clean earth cable be considered as low current cable
Why the unit sizes of hydro generating machines are not standardized as in case of thermal powerplants?
How can i calculate the Breaking capacity of molded case circuit breaker, is the breaking capacity of CB for Diesel generator shall be less than grid supply's breaker ?
what is earth-fault?when it occurs? to check where it occurs what type of test should we do?
sir, i'm preparing for hpcl exam officer trainee pls tell me how the exam ques paper pls pls
we have require a Motor (1500kW, 6.6kV, 50Hz) which shall operate at 1500rpm during 30min and after it shall run on 500rpm during 15min. The same cycle shall be repetitive during the whole working days. Which method is best and economic to achieve such type of task. VFD, VVFD, Pole changing motor etc.
The ripple frequency in output of fullwave bridge rectifier is a. Half the input b. Twice the input c. Same as input
3 shows a 415 V, 3-phase generator supplying a 3-phase 415/110 V transformer. Draw the individual and combined impedance diagrams to a base of 10 kVA. Determine the system fault kVA and the fault currents at the 415 V and 110 V busbars for short circuit faults on the transformer input or output terminals. Work in p.u. values of impedances.
If a high resistance fault occurs,then what are the changes will happen in the system?
Explain the term parallel path in dc machin ?
Where voltage are high and current to be interrupted is low the breaker preferred is:
