Interested to Buy Any Domain ? << Click Here >> for more details...
why a three phase induction motor cannot run at synchronous
speed ?
- 7 Answers
- 48562 Views
- RUET, I also Faced
- E-Mail Answers
Answer Posted / raul
if the 3 phase induction motor runs at synchronous speed,
then there will be no cutting of flux by the rotor
conductors, hence no induced emf in the rotor conductors n
hence no torque would be produced n finally the motor
stalls at synchronous speed.
| Is This Answer Correct ? | 42 Yes | 20 No |
Post New Answer View All Answers
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,
Which type of motor is used in trains, what is the rating of supply used explain working principal?
what is the usage of microcontroller in the panel board?
How do you calculate the actual power consumption of an inductive load appliance. Say, a deep freezer of 200watts
If I want to lift the water at a height 50m from ground level through two inch(diameter) metal pipe then what is the capacity of motor pump is required? is it possible in single phase supply or not?
what is the transmission loss for electrical supply? specifically a large shopping complex where the grid is half KM away, what will the % of transmission loss? is there any transmission loss for captive unit generation for above set? thanks
What is the instrument to check the rotating diode fuse of alternator in running conditions?
WHAT IS DEGREE OF COMPOUNDING IN D.C MACHINE MEANS? HOW TO READ THE OPERATING CHART FOR ANY ELECTRICAL MACHINES?
Differentiate between low pass, high pass and band pass filter?
For a 6.6kV Motor it is recommended to do megger test with 500 V d.c and not more than 5kV d.c but the Hi voltage withstand test should be performed by 12kV AC. Why the dc voltage test should be limited but AC voltage withstand test could be with such a high voltage?
Currently what is the highest capacity (MVA) of SPPg generator available in the market?
What happened when capacitor connect series in ac circuit?
How to Calculate The Neutral Earth flat design calculation for the Synchronised generator (Gen 1-650Kva, Gen 2-725Kva
What is dynamo?How it works and what is the function of dynamo in a DG.
Explain how you intend to work under pressure to meet up with deadline target?
