Electricity sometimes can be dangers , sometime got shoked
form it . It is because of volatge or Current
Answer Posted / jaswinder singh
Electricity can be dangerous because of Current flowing
through human body. If we touch a bare wire of 440 volts at
zero potential difference then we will not get shock. The
best example is that the birds can't get shocked from the
high or extra high voltage bare conductors.
Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
How to do cable sizing calculation for 750 A Neutral Earthing resistor for 33kv. the 33kv cable going to swbd. is 630mm2 3 runs.
Explain what is clipper and clamper circuits?
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT-SWITCH BOARD,MLDB,ACB,BUSBAR,ETC,......?
What is the unit of attenuation?
10 tube light connect in mcb breaker.one tube light is fault.so breaker is tribe.how fault is rectified.(using 3wire phase,earth,neutral)
what is a pulse transformer? how rise time of pulse changes when ever the voltage changes?
What is the most important precaution in any experiment with d.c. Shunt motor?
What are the factor to be consider for CT selection in 132kV substation?
In Designing the rating & accessories of a MCCB how to choose the type of releases..means what is the basis for selecting, thermal magnetic, electromagnetic & microprocessr based releases
what heppend if we are connected u1-v1-w1 as a star point in the place of u2-v2-w2 in power genration
I PURCHASED A DEISEL GENARATOR SET OF AVR TYPE& RATING 125KVA BUT SOME TIMES THE OUTPUT VOLTAGE IS FLUCTUATING WHAT ARE THE PROBABLE REASONS GIVE ME
I have made a 3 phase thyristor full bridge rectifier. But at the moment it is working only for the half bridge operation. Both the half bridges are on operation separately but when i put it into full bridge operation the oscilloscope output is zero. I rechecked that the pulses are correct for each thyristor. what could be the possible reason for this?
Define coil span?
Whether power factor should be high or low? Why?
which metal is use in shunt