What is the power factor you maintain at ur organization?
Answer Posted / rajendran.m
1.0000(unity power pactor)
| Is This Answer Correct ? | 16 Yes | 36 No |
Post New Answer View All Answers
I WANT BHEL PREVIOUS QUESTION
Practical condition in 400KV Sub station:- Breaker(open) , isolator(open), Earthing (close) at both end e.g A & B. Now Open A Stn Earthing than Open B stn Earthing (Which have a 50MVA reactor) , AND suddenly show R,Y,B phase 704KV,573KV,118KV respectively. Que is without closing of breaker how it is possible.???? My Whats app No:07621840498 for Further Discussion. Pls experts suggest.
what is the difference between electrical and electronic choke?
Define newton's law of viscosity.
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
Why hydropower stations are preferred solution for meeting peak loads in grids?
What are different types of control systems?
How to address the servo drive for motor
The power factor of the fixed load is 0.8, now the p.f is varying from 0.8 to 0.5.
In a single how much maximum current and watts using
in star-delta tranformer,if the input of star connection is 400/7v 3 kva then what is the output of delta connection?
magnetizer priciple
explain me the relation between torque, frequency,speed,voltage and current in the 3 phase induction motor?
In case of generator when we consume more power produces by it why load on generator increase and starts sound more. and how it is adjusted..
hi can any body send me syllabus of rrb electrical section engg... and past pepar also of any board...