What is difference between Boring, Reaming and Lapping?
- 4 Answers
- 63177 Views
- Essar, HMT, I also Faced
- E-Mail Answers
Answer Posted / karthick
All the three processes are machining operations
Boring:Process of producing holes of larger diameter
compared to drilling
Reaming:Process of sizing and finishing the already drilled
hole
Lapping:Process of surface finishing.It is done by rubbing
two surfaces using abrasives b/w them.As a result of
lapping a reflective surface will be produced
| Is This Answer Correct ? | 125 Yes | 26 No |
Post New Answer View All Answers
What are the causes of turbine vibration
the avg piston speed of an internal combution engine increases as cylinder dimension decreases justify?
please send me previous placement papers of cummins company
Who invented springs?
about induction motor
how can I calculate daya of pump
When effect of variations in specific heats is considered then how do maximum temperature and pressure vary compared to air standard cycle ?
send interview questins about pro_e to me mohanrvs_1984@yahoo.co.in
What are the effects of carbon on the properties of steel?
Define a mechanism?
Is the unit and normal value fuel ratio of an average diesel engine?
sampile paper for dme in rrb exam
What are the defects in exhaust valve?
What is an oil mist detector
AS I AM BEING IN PLANT ENGINEERING & MAINTENANCE DEPARTMENT I WANT ANY BOOKS RELATED TO MAINTENANCE CAN YOU GUIDE ME THE AUTHOR.
