Is expansion valve a throttle valve? why?
and what is the capillary tube and the difference between it
and the above ones?
Answer Posted / palash
I dont get the first question?
Whatever I am trying to give some answers according to the
questions.
First question is "Is expansion valve a throttle valve".
The answer is, it is not necessary always.Because there are
several types of expansion valve like
1. Hand (manual) expansion valves
2. Capillary Tubes
3. Orifice
4. Constant pressure or Automatic Expansion Valve (AEV)
5. Thermostatic Expansion Valve (TEV)
6. Float type Expansion Valve
7. Electronic Expansion Valve
Coming to the Second question,capillary tube is a
long ,narrow tube of constant diameter.the main purpose of
it is to reduce pressure from condensor to evapourator to
continue the flow.In capillary tube because of following
two reasons pressure is dropped down.
1)The refrigerant has to overcome the frictional resistance
offered by tube walls. This leads to some pressure drop
2)the average density difference in the tube (mixture of
liquid and vapour refrigerant) makes some velocity
increases which in term drops the pressure.
Coming to third question :throttling valve is not a kind
of pressure reducing valve,rather its a flow control valve
to control the flow of the system as per required for the
system
,whereas capillary tube is fixed opening type tube to
reduce the liquid refrigerant pressure to the evapourator
pressure.
sorry for the lengthy answer. :(
Is This Answer Correct ? | 16 Yes | 1 No |
Post New Answer View All Answers
What will be the cause of scavenging fire?
why the frequency of natural vibration is always greater than the forcedd vibration.??
why we use kg/cm2 instead of kg/m2 as a unit of pressure. As we know kg is a MKS unit and cm is a CGS unit. So why we use combination of both(kg/cm2)while describing the pressure.
Explain the difference between pipe and a tube.
T unionĀ support factor
Accelerometers measure acceleration. How do you measure the moment of inertia?
What causes crankcase explosion?
We select 10mm nominal thickness for Elip head of a pressure vesel. The minimum thickness after forming is 8.2mm. (Shell thickness is 8mm. The minimum thickness after forming is satisfied or not with UG-79 (d)(3) in ASME SECTION VIII, Div.1?
Please any one help me I preparing for the post of charge man in Indian ordinance factory please give me some guide line & book for this exam.my email. anoopkpandey16@gmail.com
what happen when there is moisture in the TX valve?rac
can you please give me the questions related to steels,i have an interview regarding to steels factory
Define a uniformly distributed load.
Give five differences between suction and discharge pipes?
How does an equal-arm balance work?
what is procedure of measuring operating length of mechanical seal .(in case of centrifugal pump)?