Answer Posted / nithi
Theoretically,capacitor acts as open circuit with dc
supply.i.e.it continues to store charges till the voltage
b/w the capacitor plates equal to the supply dc
voltage.once it reaches that state,then it will act as a
open circuit.that charging time is depends on the charging
resistor,value of capacitance.
this answer is applicable to the ripple-free dc supply
only.if ripple is there,then it will act as a filter.
| Is This Answer Correct ? | 20 Yes | 1 No |
Post New Answer View All Answers
what are the application of over current relay?
write circuit diagram for a motor rotate in forward direction once it started and when pressed the same button it should rotate in anticlockwise.
why is the power generator connected as star earthed or star earthed through reactance and what its features ?
how can we change the polarity of Alternating current rapidly? how frequency of ac can be controlled and changed easily?
sir iam a 3rd yr eee student.no core company comes for recruitment to our college.my aim is to be placed in l and t.tell me the procedures.
what is stper motor
What is the maximum operating temperature for a thermoplastic insulated cable?
Draw the DOL starter and star delta starter drawing?
why Lightening Arrester Probe sharp at Top of telecom tower.
What shall be the secondary output voltage if the primary winding of a 220/6V, 50 Hz transformer is energized by an 110V, 60 Hz supply?
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,
How to do fabrication , busbar and wiring cost for : 1. LT Panels 2. C& R Panel
how to calculate compresor capacity?
difine electrical ballast in HPSVL
how to ctrl motor by use of ac or dc drive.plz explain evdintly