How to model "IF ELSE" statement in matlab simulink?
- 4 Answers
- 21785 Views
- I also Faced
- E-Mail Answers
Answer Posted / kosal ram
use two switches, or u can use the if block in the simulink.
| Is This Answer Correct ? | 9 Yes | 6 No |
Post New Answer View All Answers
what is PWM in IGBT and how it works for drive.?
how to determine the cable size...pls explain me with the formula taking particular load....does the factors like impedance & short circuit rating influence the cable size, if so how....
What is the minimum value of hfe for the oscillations in transistorized rc phase shift oscillator?
how current is reverse from its normal direction during the fault?
what is the chemical name and formula of refrigarent R-134a.
A cotter joint is generally used to transmit
what is different between relay and plc?
how is positive, negative, zero sequence is happen.. how is effect on 3 phase system
Can we use shunt trip coil instead of trip coil with protection relay for protection?
ITI r/tv trade APPLY (J.T.O VACANCEY) ALSO INCLUD AITT ELECTRONIC,WRITEEN XAM DONE 23.03.10 BUT NO RESPONCE WHY ANATHER ID gopal_gh007@rediffmail.com
i will applied in 1U-1W on 440 volt primary delta side. what is the result of magtic balance test
How to Design green buildings services? What is the advantage to design green building?
IF % IMPEDANCE OF A TRANSFORMER IS INCREASED FROM 5.8% TO 8% HOW MUCH THE EFFICIENCY OF THE TRANSFORMER WILL COME DOWN?
What will be the current drawn by HT motor, if low voltage is applied.. any formula to calculate the LT amps of HT motor.?
Define active filter?
