Interested to Buy Any Domain ? << Click Here >> for more details...
how to use one 4-20mA signal for two indicater or controller
& give necessary precaution.
- 2 Answers
- 4945 Views
- I also Faced
- E-Mail Answers
Answer Posted / anand
Use Isolatrer/Mux 1 I/P & 2 output.......
1 230 v source to energise the mux and 2 outputs can be
got...
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
What is the meaning of wet leg
the pump holds on run indication into the dcs and filed local control panel remote push button condition operaton wrong like when the push button pushing conditions the pump is off and the push button release condition the pump is on totally opposite condition . And control room inside give the stop command into dcs just 1secon relay engage and again normal condition. How can I slove
How to calibration a control valve?
what is RTV function in in process control?
detail of mass flow meter pricipal
I have energy meter for educational project having 0.5s class but my friend need 0.2s class meter , which one is good for that purpose and what is the actual difference of that two classes , need very easy example also.??
Displace type LT to be calibrated in workshop, wt. 40, dia- 60 mm, density- 0.8kg/cm3.
Why do we floating DC in DC system.
What is the diffrence between ff tx and non ff tx
What is instrumentation measurement?
please send me some question papers of HPCL aptitude test ?? please send it to bipinb.28@gmail.com ...
how to tune siemens sipart electro pneumatic positioner..plz tel me..
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
please tel me the calibration of pneumatic controler.
how will you check torque value during Factory acceptance Test for control valve/ESD ON/OFF VALE how will you confirm this torque value is being correct, Which document will you be refer.
