Interested to Buy Any Domain ? << Click Here >> for more details...
what is difference between a scada ,dcs & hmi?
- 2 Answers
- 6836 Views
- MTS, Samtel, I also Faced
- E-Mail Answers
Answer Posted / jasim
distribution control system and human machine interface
and supervisory control and data acquisition
| Is This Answer Correct ? | 18 Yes | 13 No |
Post New Answer View All Answers
What environmental controls?
why data registers are needed in PLC ?
if zero ohm is not adjusted on shorting the two terminal of multimeter what does it indicate
why we give dedusting steam in feed gas coils in convection section of primary reformer?
why comparable interface is marker interface in java?
Why normally we don’t use relay for digital input module?
What is quality management system? Weather qms is suitable, adequate and effective or not? Is there any quality policy? Is there any quality objective? If yes, then what are they? How they are planning to achieve quality objectives? Do they are measure quality objectives?
What are the problems involved with queuing theory?
what does EN230 material mean?
What is v/f control, sensor less control and sensored control for ac vfd?
HOW TO EVALUATE THE ACCURACY ADJUSTMENT pressure switches, given a point in switching operations or on the extent Pressure Switch
ANY ONE USED/INTERFACED CITECT VERSION 6.0/1 OR 7.0/1 TO SIEMENS S7-300 OR S7-400 CONTROLLER IF PLEASE TELL ME THE COMMUNICATION STRUCTURE AND ADDRESS CONSIDERATION FOR DI,DO,AI,AO please mail the details lok_pallapolu@yahoo.com Ph:09247513753 hyderabad
if salary paid per month rs. 50000/- of male <65 i will deduct tds from his salary please what i will do explain?
Let’s say we live in a country that gets very cold, in Northern America / Europe. In winter, we monitor the ouside temperature, so that heaters can be switched on, inside the house. The idea is that, the colder it is outside, the warmer it should be inside. The heating side of things is just a heater that is either switched on, or switched off. Just from the information that has been given, please discuss this matter in depth. Provide reference to OPEN / CLOSED loop control, FEEDFORWARD / FEEDBACK control and MODULATING / ON_OFF control raised in the discussion.
how a three wire proximity can be used in place of two wire proximity?
