Answer Posted / parneet singh

we use oil because there is no lubrication facility in case
of two stroke engines as they are double acting and the
fuel has to be mixed in the lubricating oil but in case of
4 stroke engines,they are separated by the moving piston.

What are your favourite subjects in your graduation and why?

969

---

If a diesel engine is running at 2500 RPM, How much would be RPM of turbocharger?

1353

---

1) can any one tell how dozer transmission system power terrain --track

2570

---

What is extrusion? What is extrusion aluminum and what are its uses?

994

---

Tell me the formula of heat loss in a pipe.

1050

---

Hi guys! I buyed this clone carprog but i realized that not reading 24cxx. I tried 93cxx and 25cxx and it read.But 24cxx not.I tried to put external power.Of course the eeprom was soldered out.The interface is new and never read 24cxx.I tried many 24cxx .Is there a solution for this problem? I read in other forum that need to replaced 74hc125D with 74hc125M 4 pieces. thanks!

2133

---

Slip joints are provided in the propeller shaft a) To adjust the inclination of the propeller shaft b) To adjust the length of the propeller shaft c) To prevent the whirling of the propeller shaft d) To adjust the up and down movement of the rear axle

1347

---

How bhp is measured?

982

---

How does the thermostat work?

1065

---

State some of kingpin offset application.

1058

---

What is bearing and what are the different types of bearing ?

1105

---

Hard shifting of gears would result when a) There is rapid engagement of gears b) There is less heat dissipation c) The clutch inertia is very high d) There is no clutch free pedal play

1536

---

How air conditioners work in cars?

1110

---

Which engines have the high mechanical efficiency either 2 stroke engines or 4 stroke engines?

961

---

Discuss the Otto cycle.

1047

---