Interested to Buy Any Domain ? << Click Here >> for more details...
WHAT IS THE DIFF BETWEEN FREQUENCY AND INTENSITY?HOW IT
WORKS IN FLAME SCANNER ?
- 1 Answers
- 7998 Views
- I also Faced
- E-Mail Answers
Answer Posted / palaniappan balagurusamy
Flame scanners detect the UV or IR waves generated from the
hydrocarbon combustion. Visible type flame scanners are
also available.
Each type of hydrocarbon give out different frequencies of
UV / IR / visible spectrum.
Intensity component of the flame in a flame scanner is
detected to show the operator how intense the flame is.
The frequency of the flame is detected to discriminate
between different hydrocarbon flames. For example in an
boiler combustion flame scanner using oil and coal in
different elevtions, this facility will be useful. The
flame scanner in one elevation buring oil will not sense
the flame of the other elevation burning coal.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
Hi, Is there any smart plant instrumentation design training institute in Bangalore?
How to calibrate radar type level transmitter for interface level? Total liquid(liq.1 and liq.2), level both the liq individually? For. Both the liquid levels how the signal will go from transmitter to dcs? How to calibrate. Single radar 9:26:55 AM for 2 different liquids in a tank?
why orfice is not used for main steam flow calculation
Q-Explain the different load conditions that will produced different offset which may or may not be acceptable to thhe control function
how u calibrate pneumatic n motorized c/v?
WHY THE DEGREE OF VALVE PLUG AND VALVE SEAT IS SLIGTLY DIFFERENT I CONTROL VALVE TRIM DESIGN
what is performance test.need defination
Draw a wheatstone bridge circuit showing supply, meter and 3 wire RTD connection
components of control circuit belongs to control valve
kindly sent some demo question and answer
Give 2 application of quartz crystal used for process parameter measurement.
What is the difference between modbus,fieldbus & profibus
1.can you use SCADA instead of DCS,DCS instead SCADA 2.Difference between DCS and PLC,can their role be reversed i.e. role interchange 3.Difference between RTU and PLC
how many pulses are required by a ac induction servo motor of 4 poles with 50 Hz frequency to rotate by 1 degree?
what happen if i increase height of displacer type LT.accuracy or sensitivity are affected.why?
