Interested to Buy Any Domain ? << Click Here >> for more details...
what would be the earth to neutral voltage in industries? if
it is not main Taine then what will happen?
- 4 Answers
- 6270 Views
- I also Faced
- E-Mail Answers
Answer Posted / prajeesh
I think it is limited to 2 volts. If it increases, that will cause break down of electronic cards...
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
-What shall be short circuit current of LV switchgear for a 1000 kva, 11.415kv, 3 phase tranformer with 5% reactance.
5- What is the task (function) of the excitation and isolation transformers in power plant? 6- What is the task (function) of LCI (A), LCI (B) and LCI (COS) in power plant? : LCI (A) and LCI(B) are load commutating inverter for generator turbine starting. , LCI (COS) is load commutating inverter change over switch
A logic circuit that provides a HIGH output if one input or the other input, but not both, is HIGH, is a(n)?
Is there any relevant technique to produce power from light and heat energy of the sun simultaneosly from same rays of light?
How one may guess the direction from which the distribution line is incoming if there is no pole plate on poles?
what happens when dc generator coupled with cycle shaft.also explain what happens when its loaded
what is sevice settings for mccb?How can be it setted?
explain different types of d.c motors?
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor reactance at stand still is A 2 ohm B 1.25 ohm C 3.15 ohm D 2.25 ohm
how we can decide that what value of ht line will come to any commercial building? (ans except According to the building load)
In control room of our one plant there is a continuously the incoming power goes to PC is vary,means in stabilizer it continuously indicate from high input to low and low input to high. what is the reason and its solution.
What are the causes of unbalanced current on 34.5kv feeder Ia=0.05,Ib= 0.25, Ic=0.15 and In=0.27 prior to tripping current are balance?
1. for eg, capacitor is used for many purposes(it act as filter, oscillator, bypass capacitor, memory storage etc...) 2. Please tell me some example circuits for different uses of capacitor( whenever and whereever and however we used capacitor as a filter, oscillator tuning etc..) 3. similarly for inductor and resistors(it act as what?) and when and how we want to act as like that?, and how we can used these components depends upon our requirments with example circuits and explanation? design to act as these components depends
What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works?
Why Neutral Isolation is required?
