Interested to Buy Any Domain ? << Click Here >> for more details...
What is the size of cable to be used for a Space Heater in
UPS 160KVA of carrying 10 Amps current with 240 V ,1 Phase?
- 3 Answers
- 5322 Views
- I also Faced
- E-Mail Answers
Answer Posted / pillay
For a load of 10 amps a 2.5 mm sq cable protected with a
suitable breaker should be good.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
l&t switch FN 63 handle position can we change
Differentiate between magnetic field and magnetic flux?
WRITEDOWN FEW RELY CODES
10 tube light connect in mcb breaker.one tube light is fault.so breaker is tribe.how fault is rectified.(using 3wire phase,earth,neutral)
1. What is differential relay? How it operates? 2.How to calculate the Short Circuit Impedance in Transformer? 3.What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works? 4. While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply? 5. What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer? 6. Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example? 7. Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient? 8. What should be the minimum and maximum ohmic value for earthing? 9. Why DC Currents are not used in transformer? 10. What is the Frequency while we step up the voltage from 220V to 11KV? Is it possible? Explain it?
Describe the colour rendering properties of i) tungsten filament lamps ii) tubular fluorescent lamp
how to test power transformer.YNd11
we have one oven for 12 zone we are installed ir lamp in oven we control load from thyrister and 0 to 5vdc so our zone no 8 getting bright in fraction of second so what we do.. Please answer
Please tell me the earthing procedures adopted for the STAR-STAR 3 Phase transformer in india and give a better sugession for earthing
HOW DO YOU CAN CHECK A 15KV DIODE, WHETHER IT IS OK OR NOT?
what is the importance of Partial Dischage test for Electrical Equipments
What is the classification of hydro projects based on installed capacity?
which VFD is better ( LT or HT)
How stabilizer works??
how to select the no. of brushes in a lap winding?
