Interested to Buy Any Domain ? << Click Here >> for more details...
when running 2 nos 450kva dg sets in parallel operation ,in
one Dg set power factor and Kvar going to lagging and ampere
suddenly going high,please give me suggestion to correct the
same.
- 2 Answers
- 7013 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
May be due to over excitation.If you are using AVR ,run on
manual channel to check the PLC and auto channel
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
what sort of general awareness questions are asked in o.n.g.c entrance exam?????????????????
How to do bus bar short circuit calculation for 230KV/11kv, 60 MVA Substation?
what is the effect of change in supply frequency on load angle of synchronous motor,all other parameters remaining same?
pls tell what are doing the three phase motor star and delta connetion with circuit diagram and control wiring .
If a air condition consume 2.50 to 3.00 amp then how much it will consume in watts if it is running 10 hours out of 24 hours????
how to handle 2500 kva transformar
what is differentila pilot supervision in the incomer control panel in the power station?
what is the working process of over & under voltage relay.
A 11KV, 1200 A breaker combination fixed in a cubicle for HT motor.Is normally for 11 KV motor fuse is using? if Yes, What range fuse is required?
Why do we require transformer with less specific weight if supply frequency is increased?
which mm cable should be used for 1.hp immersible pump motor for the distance of 330 metres?
What is the feedback in the control system?
How to decide cable tray size?
how we arrange the hv side with delta connection in case 33/11kv of transformer.
what are factors to be consider to design a HT & LT motor?
